Tempered glass is classified as safety glass. Tempered glass is actually a kind of prestressed glass. In order to improve the strength of the glass, chemical or physical methods are generally used to form compressive stress on the surface of the glass. When the glass is subjected to external forces, it mainly offsets the surface stress, and then improves the bearing capacity and enhances the glass's own resistance Wind pressure, cold and heat, shock, etc. Even so, the tempered glass door glass still has a self-detonation rate of three-thousandths. In addition to the quality of the tempered glass, the prudent use of equipment is also an important factor related to safety. Customized doors and windows, cutting of tempered glass The tempered glass door assumes that it does not meet the equipment standards, and then rework is very troublesome, so it must be accurate at the time of the initial measurement.

The measurement of tempered glass mainly includes the width and height of the glass plate. When measuring the width of the glass plate, measure at the bottom, middle, and top, and select the small scale as the width of the cut. If the data obtained from the top, middle and bottom are consistent, then the measured width is reduced by 3-5 mm as the cutting width of the glass. Similarly, the height of the glass plate should include the position of the device that penetrates into the upper and lower rails, so it is generally taken 3-5mm smaller than the measured data for cutting. After the tempered glass is processed and the glass plate of the device is cut to scale, it is generally necessary to chamfer the four corners. Generally, a fine grinding wheel block is used to slowly and finely grind. Then, fix the bottom bracket, aluminum alloy doors and windows are fixed by aluminum alloy frame, fixed on the frame with aluminum corners.

Use a glass suction cup to first move the glass plate to the west longitude and place the glass in place. Pierce the upper part of the glass plate into the limit groove of the door frame, and then place the lower part of the glass plate in the counter slit of the decorative surface of the bottom bracket. Glue sealing, door and window molding, windproof and waterproof glass plate fixed thick, glue sealing at the top of the limiting groove and the bottom bracket, and the gap between the glass plate and the frame column. Use a plastic sheet to flatten the glue on both sides of the glass plate and wipe off the residue. Be careful when scrubbing the debris, try not to use sharp objects such as blades. After confirming the height of the door leaf, pierce the small wooden strips from both sides at the same time on the glass plate and the gaps on both sides of the entrance and exit rails. , And then use the above method to deal with the remnants. Tempered glass belongs to safety glass and is widely used in places with high mechanical strength and safety requirements.