buildingCurtain wall glassInstallation process requirements:

1. The glass of the clear-frame glass curtain wall should not directly contact with the components. There must be a certain gap between the glass and the bottom of the groove of the component. At least two pieces of glass should be placed under the same width as the slot width, and the length should not be less than 1 00mm elastic positioning pad. The amount of embedding on both sides of the glass and the gap should meet the design requirements, the material and model of the rubber strips around the glass should meet the design requirements, the inlay should be flat, the rubber strip size should be longer than the inner groove of the frame 5%-2%, the rubber strip is in At the corner, the inclined surface should be disconnected, and the adhesive should be firmly inserted into the groove.

2. Hidden frame or semi-hidden frame glass curtain wall, two aluminum alloy or stainless steel supporting bars should be set at the lower end of each glass, the length should not be less than 100 mm, and the thickness should not be less than {{0 }} mm, the outer end of the bracket should be lower than the outer surface of the glass 2 mm.

3. When installing glass, the orientation of the glass should meet the design requirements. The installation of heat reflective glass should face the coated surface indoors and the uncoated surface outdoor.

4. After the glass is installed, seal the sealant around the glass. The sealant should be full, dense, continuous, uniform and free of bubbles, and promptly clean the excess glue outside the glue joint.